- Thread starter
- #41
I saw that smaller hole next to the larger hole for the tube but wasn't sure what it was for. Thanks for the information and I will put that grub screw in tonight. I tried putting the antenna in the receiver box for my MT410 but I ran into range issues so I am running that one out of the box as well. I keep the antenna tube under the body so that it is somewhat protected.1. The antenna tube goes in the hole in the rear of the receiver box then there should be a grub screw that screws into the smaller hole next to it so it wedges it in place. Personally I just wrap antenna wire neatly and stuff in side the box. Every antenna I have had installed just gets ripped off eventually, unless you tuck it under the body I suppose.
2. When you say continue to run do you mean "with power" or it will it just keep rolling? perhaps its an ESC setting?
I will squeeze the throttle for just a split second and the motor will follow the throttle input that I do but when I let off of the throttle, the motor keeps spinning, with like 25% power, for another 2-4 seconds. I'm thinking I may need to adjust some kind of throttle neutral deadband width or sensitivity (assuming I can) or something but figured I would see if anyone else has had this issue ever.
Last edited: