410 2.0 Convert my Tekno SCT410 2.0 from 12mm hex hubs to 17mm

[liufunyu]

I’m planning to convert my Tekno SCT410 2.0 from 12mm hex hubs to 17mm hex hubs so I can use a different set of wheels. Other than TKR5569, TKR9588, and the set screws, are there any additional parts I need to purchase for this conversion?

 

[RC-Steve]

You've done your homework. I don't see where the hexes say they come with wheel nuts. They will be the same wheel nuts that come on the 48 trucks.

 

[headsmell]

I think you are missing TKR1602 (dont forget Loctite on these)
Also if you are running 4s, change the center diff gears with the TKR5149 & TKR5150

 

[liufunyu]

I think you are missing TKR1602 (dont forget Loctite on these)
Also if you are running 4s, change the center diff gears with the TKR5149 & TKR5150

You mean TKR5149 & TKR5150 are more strong ?

 

[headsmell]

You mean TKR5149 & TKR5150 are more strong ?

Yes, if you are running 4s the plastic in the center diff will break.

If you are running 2s, you should be fine with the stock grears.

I'm running a HW 4268 2200kv motor/ 16th tooth pinion in my sct410.

 

[liufunyu]

Yes, if you are running 4s the plastic in the center diff will break.

If you are running 2s, you should be fine with the stock grears.

I'm running a HW 4268 2200kv motor/ 16th tooth pinion in my sct410.

My motor 3300KV, 4S battery , then... all the tires are blown !

 

[headsmell]

My motor 3300KV, 4S battery , then... all the tires are blown !

View attachment 11951

View attachment 11952

LOL yeah, I'd beef up your gears and get some proper 1/8 tires

 

[RustyUs]

My motor 3300KV, 4S battery , then... all the tires are blown !

View attachment 11952

Oh, my. You got another motor on order?

 

[Dusty]

I’m planning to convert my Tekno SCT410 2.0 from 12mm hex hubs to 17mm hex hubs so I can use a different set of wheels. Other than TKR5569, TKR9588, and the set screws, are there any additional parts I need to purchase for this conversion?

Hi, I have the M2C7017 on the SCT410 2.0. Fit perfectly and everything is needed. However, have +5mm offset.