nub
Well-known member
- Messages
- 238
- Reaction score
- 154
- Location
- Texas
- Tekno RC's
- EB410
- EB48
- ET48
- MT410
- SCT410
- Driving Style
- Basher
Does anyone else balance their wheel/tires on their EB410 or .2?
I've been using clay for several years and was waiting on a set of front wheels/tires to show up. The rears were already common to a 2wd buggy I have so was good there.
I generally press the clay really flat to make it easier to clean the back of the wheels and not catch a bunch of crud. What I found was once mounted the rear bearing carrier and the swept arm on the front that the steering arm attach to are so close to the inside of the hoop it swept the clay off. I noticed these bits were close before hand but didn't think this would happen.
Does anyone have any suggestions on something besides clay that is thin? I've seen some of the weighted tapes but they don't say and you can't tell how thick they are.
I've been using clay for several years and was waiting on a set of front wheels/tires to show up. The rears were already common to a 2wd buggy I have so was good there.
I generally press the clay really flat to make it easier to clean the back of the wheels and not catch a bunch of crud. What I found was once mounted the rear bearing carrier and the swept arm on the front that the steering arm attach to are so close to the inside of the hoop it swept the clay off. I noticed these bits were close before hand but didn't think this would happen.
Does anyone have any suggestions on something besides clay that is thin? I've seen some of the weighted tapes but they don't say and you can't tell how thick they are.