adrock
New member
Hi out there,
I am just building my MT410 after some rc car absence (previous car was a Tamiya Fighter Buggy .
It will become a LWB version using the M2C long chassis and the plan is also to mount a wing (found some info about this here already).
However, currently I am at building step "H" and there is a question:
There are those pin sleeves (TKR5054A and TKR5055A). How is it supposed to be built?
- Tighten the screw inside the sleeve, so the screw may not rotate inside the sleeve. Then the sleeve itself will rotate in the plastic part where it is sitting.
or
- Leave the screw inside the sleeve a little bit loose, so the screw can rotate freely inside the sleeve
Hope my question is clear, I am not an English native speaker...
Thanks & regards
Markus
I am just building my MT410 after some rc car absence (previous car was a Tamiya Fighter Buggy .
It will become a LWB version using the M2C long chassis and the plan is also to mount a wing (found some info about this here already).
However, currently I am at building step "H" and there is a question:
There are those pin sleeves (TKR5054A and TKR5055A). How is it supposed to be built?
- Tighten the screw inside the sleeve, so the screw may not rotate inside the sleeve. Then the sleeve itself will rotate in the plastic part where it is sitting.
or
- Leave the screw inside the sleeve a little bit loose, so the screw can rotate freely inside the sleeve
Hope my question is clear, I am not an English native speaker...
Thanks & regards
Markus