MT410 2.0 First Run

[jackdc100]

When I turn on my new MT410 2.0 what do I need to take care of before I drive it around? I am running the following: Hobbywing EZRun MAX10 G2 140 Amp Sensored Brushless Waterproof ESC/3665SD Motor Combo (3200kV), Flysky Noble NB4+ 2.4G 8CH Radio Transmitter Remote Controller with FGR4S Receiver, DXF High Voltage 3S 9200 mAh 11.4V 130C Batteria Lipo ad Alta Capacità Hardcase con XT90, EcoPower WP250T Waterproof MEGA Torque Metal Gear/Metal Case Servo, IMARS D300 Plus Gens Ace Lipo Battery Charger G-Tech Series Dual Lipo Balance Charger AC 300W DC 700W 16A Smart Charger for 1s~6s Lipo Batteries, Life/NiCd/MH/LiHV, Plug&Play, Tekno RC "M5" Hardened Steel Mod1 Pinion Gear w/5mm Bore (12T).

Do I need to just set up endpoints for the throttle and steering? Is there anything else that I should be aware of? I haven't built an electric kit since the 90s so I need some guidance. Thanks in advance!

​

 

[ducatiti]

If I were in your shoes, I will start off to check if the motor is turning the right direction.

I would then follow the procedure to calibrate the ESC and set the end points for the steering.

Lots of YT videos out there with basic setups.

Have fun!

 

[RCFinger]

 

[jackdc100]

If I were in your shoes, I will start off to check if the motor is turning the right direction.

I would then follow the procedure to calibrate the ESC and set the end points for the steering.

Lots of YT videos out there with basic setups.

Have fun!

Ok thanks. Yeah I have checked out some videos on YouTube but I wanted to make sure that I am not missing anything.

 

[jackdc100]

Thanks! Adam is the man

 

[YourConfused]

Just make sure to check your setup with the wheels off the ground, especially if doing so indoors.