Answers on a postcard. The cable got covered in sand and vibrations made the grit ware into the cable as it slipped under the motor.
Best way to fix this?
I've already snipped out the bad piece of wire, and part prepped for some fix or another.
I'm thinking snip all four and just solder and heat shrink extension wires in to place so I can better route the switch.
Best way to fix this?
I've already snipped out the bad piece of wire, and part prepped for some fix or another.
I'm thinking snip all four and just solder and heat shrink extension wires in to place so I can better route the switch.