• Welcome to Tekno RC Forums! Are you a Tekno RC fan? If so you're in luck as you've have arrived to the biggest and best Tekno RC community.

    Come join our community and ask your questions, show off your Tekno RCs and share your experience!

48.3 Eb48.3.5 conversion

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

cAn”t DrIv3 4 sH!t cOol

Well-known member
Messages
65
Reaction score
35
All done with converting the front and rear .4 swap and added the lunsford turnbuckles. Added the .4 shocks to the front.also added split center diff
 

Attachments

  • 15967014183964874664026117498296.jpg
    15967014183964874664026117498296.jpg
    135.9 KB · Views: 442
  • 15967014765372570225106987376044.jpg
    15967014765372570225106987376044.jpg
    122.8 KB · Views: 422
  • 15967015430953909983590034781595.jpg
    15967015430953909983590034781595.jpg
    144.8 KB · Views: 375
  • 15967015953845302870939641717987.jpg
    15967015953845302870939641717987.jpg
    131.7 KB · Views: 423
  • 15967020573141599908261007281077.jpg
    15967020573141599908261007281077.jpg
    149.3 KB · Views: 406
If you're running the .4 rear hubs with the .2 rear arms you need to also run the wide pivot C and D blocks from the .4. If you don't the driveshafts are going to hit the outdrives during the suspension cycle.
 
are those 2.0 hubs on .4 arms? Nice work boss!

edit : ahh i see its .4 setup, exotek hubs.. may grab em as well for my .4!
 
If you're running the .4 rear hubs with the .2 rear arms you need to also run the wide pivot C and D blocks from the .4. If you don't the driveshafts are going to hit the outdrives during the suspension cycle.
I run tomorrow...thx for pointing that out a whole extra for this mode
 
Have u gotten her out to compare the difference
yeah car runs great wheels kinda cock eyed lol and the turning is much better it definitely took out the wobbly or slope that I was having
 

Attachments

  • image.jpg
    image.jpg
    75.3 KB · Views: 172
  • image.jpg
    image.jpg
    103.5 KB · Views: 182
  • image.jpg
    image.jpg
    87.6 KB · Views: 191
  • image.jpg
    image.jpg
    128.8 KB · Views: 173
I checked it out my .3 driveshafts are to far into the .3 outdrive cupI didn't use the.4 driveshafts fk i got back to hobbyshop.
The driveshafts between the .3 and the .4 are the same length. The problem is that the .4 rear hubs have the lower pin further out from center (closer to the wheel) than the previous versions. Since the arms are all the same length you need to use the .4's wider C and D blocks to get the track width back to the correct spot.
 

Recent Popular Liked

Back
Top