Hey everyone,
Ran my first race this weekend with my ET48 and EB48. However, I had issues the last two races with my EB48 losing signal for about 2 seconds intermittently. I was first in my main but it kept randomly cutting out so I ended up taking it more easy just so I could finish the race and try to keep from running into walls when I lost all control.
What should I be looking at? I checked all the wires and solder points on the esc wires. I checked my receiver and everything was still firmly plugged in. The only thing I did find was I checked my transmitter wire for the battery pack and when I pushed on it it wasn't plugged in fully (probably about 80-90% plugged in) and I did change my transmitter batteries before my last runs. Would that have been enough to cause the issues? Obviously, I'll find out once I get to run the car some more but since it's intermittently it's hard to reproduce. I'm running a Futaba 4Pm with R304SB-E receiver if that helps at all.
Ran my first race this weekend with my ET48 and EB48. However, I had issues the last two races with my EB48 losing signal for about 2 seconds intermittently. I was first in my main but it kept randomly cutting out so I ended up taking it more easy just so I could finish the race and try to keep from running into walls when I lost all control.
What should I be looking at? I checked all the wires and solder points on the esc wires. I checked my receiver and everything was still firmly plugged in. The only thing I did find was I checked my transmitter wire for the battery pack and when I pushed on it it wasn't plugged in fully (probably about 80-90% plugged in) and I did change my transmitter batteries before my last runs. Would that have been enough to cause the issues? Obviously, I'll find out once I get to run the car some more but since it's intermittently it's hard to reproduce. I'm running a Futaba 4Pm with R304SB-E receiver if that helps at all.