• Welcome to Tekno RC Forums! Are you a Tekno RC fan? If so you're in luck as you've have arrived to the biggest and best Tekno RC community.

    Come join our community and ask your questions, show off your Tekno RCs and share your experience!

48.3 Here is my progress REBUILD MT410/ET48.3

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
The ET48.3 chassis is a good choice, amazing balance and stability. Love those trucks. I have two, one is m2c-ed for bashing and the other one is stock for racing.

My next servo will be a Savox 229x. Just installed a 2274 on a buggy and could not be happier.
 
90 % done
 

Attachments

  • 20200423_133901.jpg
    20200423_133901.jpg
    203.3 KB · Views: 249
  • 20200423_133853.jpg
    20200423_133853.jpg
    157.6 KB · Views: 268
Dude very noice :) really cool creation!
have you tried this with plastic rim proline truggy tires? took me a while to finally put truggy tires on my et48 because i didnt think the treads were aggressive enough - but now ill never go back. #1 rotating mass reduction is huge effect on hub bearing life. #2 way better at turning, braking and launch. #3 (i was using 1/8 buggy tires up till then) gearing smoothed way out, went from 21T pinion @50mph to 17T @ 50mph and it became alot easier to control the throttle.
i recommend buckshots... i know, it was painful for me to shelf my 150$ set of rims too.
 
Last edited:

Recent Popular Liked

Back
Top