I have an ET410.2 with the stock spur gear 53t, 32 pitch, composite, black, EB/ET410) is included with the ET410 and a 16t pinion gear. I am running an XErun 4300kv motor and the XR10 esc. It is fast enough, but tends to overheat after about 5 to 6 minutes. What can I do to create a longer run time?
-
Welcome to Tekno RC Forums! Are you a Tekno RC fan? If so you're in luck as you've have arrived to the biggest and best Tekno RC community.
Come join our community and ask your questions, show off your Tekno RCs and share your experience!
Overheating Motor
- Thread starter Ozzie1972
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 1,329
- Reaction score
- 1,118
- Location
- Austin, TX
- Tekno RC's
- EB410
- EB48
- ET48
- ET410
- MT410
- SCT410
- Driving Style
- Racer
I found it necessary to run a 4-pole 540 motor with a 20T pinion to get the best results, if I was to run the ET410 today I would get the XeRun 3652-3800KV with a 20T pinion:
https://www.hobbywingdirect.com/col...oducts/xerun-3652sd-motor?variant=28086278737
more info on my setup here:
https://www.hobbywingdirect.com/col...oducts/xerun-3652sd-motor?variant=28086278737
more info on my setup here:
What temps has the motor seen?
What XR10 speed control? Hybrid mode?
Have you done any of the normal stuff like checking for binding, blown bearings, drop a tooth or two on the pinion gear, and recheck temps?
What XR10 speed control? Hybrid mode?
Have you done any of the normal stuff like checking for binding, blown bearings, drop a tooth or two on the pinion gear, and recheck temps?
