Garlicbronco
Member
- Messages
- 21
- Reaction score
- 4
i got the aluminum shock caps and figured i could use the orings and stuff that were supplied for the composite caps, but now im second guessing myself that i need the other part #
-
Welcome to Tekno RC Forums! Are you a Tekno RC fan? If so you're in luck as you've have arrived to the biggest and best Tekno RC community.
Come join our community and ask your questions, show off your Tekno RCs and share your experience!
410 2.0 aluminum shock caps
- Thread starter Garlicbronco
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Correct. The bleeder screws, and o-rings from kit are used in/on the aluminum caps.
Garlicbronco
Member
- Messages
- 21
- Reaction score
- 4
- Thread starter
- #3
beautiful, thanks asked and got the same answer elsewhere but always good to get two answers
Well, count me in. I ordered another set of the aluminum shock caps. 
Last edited:
I went ahead and played with my other toys while putting off changing out the shock caps. Oh, man. I feel like an idiot. The rear cap, pictured above, had only loosened. While inspecting the other rear shock, that cap had loosened a bit as well, but not enough to make a mess like the other shock did.
Oh well, nice shiny caps are on now. Just gotta keep and eye on them. Finger/hand tight is all I ever do when it comes to tightening caps down.
