ADU Racing firing up the CNC for the MT!!!

[RCFinger]

If ADU is listening, I hope you guys fix the C and D blocks pin holes for better fitment before I buy your blocks.

They do fit with a little encouragement. I replaced my gearboxes with Allracing Alu ones and while I was at it i gave the holes in the D block a tiny grind with the Dremel, they went back together perfectly. Don't know why the the Toe-in isn't built into the arms..?

 

[RC-Steve]

This is a picture of the A block I installed one battery pack ago.

 

[RCFinger]

This is a picture of the A block I installed one battery pack ago.

View attachment 11523

Yea the stockers are cheap. Needs a revision imo, but i would upgrade asap. Nice skid plate though, where's it from?

 

[RC-Steve]

Yea the stockers are cheap. Needs a revision imo, but i would upgrade asap. Nice skid plate though, where's it from?

All ready ordered them, delivery early November.
The skid plates are Tekno Ti. www.tekno-ti.com

 

[RC-Steve]

The front ADU hinge pin retainers went on just fine. The rears were a battle to get on and get lined up. The rear hinge retainer pin holes need to be angled. I did get them on and and the truck works.

Tekno-Ti titanium skid plates. They are too thin and there isn't enough overlap with the mounting screws. When they catch on something they peel off like a banana peel. I started with two and ended my drive with only one. I'm assuming it's out in the grass somewhere at the dirt park. I still got the rear so I'm good.