sissy lettice
Active member
- Messages
- 25
- Reaction score
- 30
I was working on some projects where I was printing HTD pulleys for belt driven transmissions and decided to try it on my OG MT410 (V1).
She's sooo smooth and quiet now. Been bashing it for about 2 weeks and it's rock solid.
I'm running HTD 5mm pitch belts with pinion:spur ratio @ 14:27
The mod is very simple as the pinion is a stock pulley and the spur is a 3d printed "sleeve" that fits around the center diff casing. Then you install the diff as usual but with the mod-1 gear facing the rear. If you ever need to switch back, it takes about 10 minutes to flip the diff and swap the pinion.
She's sooo smooth and quiet now. Been bashing it for about 2 weeks and it's rock solid.
I'm running HTD 5mm pitch belts with pinion:spur ratio @ 14:27
The mod is very simple as the pinion is a stock pulley and the spur is a 3d printed "sleeve" that fits around the center diff casing. Then you install the diff as usual but with the mod-1 gear facing the rear. If you ever need to switch back, it takes about 10 minutes to flip the diff and swap the pinion.
Last edited: