Hi All
I’ve just finished my new Tekno 2.1 build and used my old electrics out of my 48.4 which ran faultless.
after installation and calibration the motor is either on or off like a switch and i can’t figure out how to change this.
i’m using a sanwa M12srs radio and a hobbywing 1900kv motor.
Any help appreciated as i’m now at a loss after countless recalibrations and checking solder joints.
I’ve just finished my new Tekno 2.1 build and used my old electrics out of my 48.4 which ran faultless.
after installation and calibration the motor is either on or off like a switch and i can’t figure out how to change this.
i’m using a sanwa M12srs radio and a hobbywing 1900kv motor.
Any help appreciated as i’m now at a loss after countless recalibrations and checking solder joints.