Hi, new to the tekno build.

[Alan0823]

Hi, forum im currently building the tekno mt410 i started it yesterday and ran into a situation, how do anyone get there servo into that little box on there pics on how its done? I don't wanna damage my new servo, was thinking of drilling a hole in the side of it and run my wires that way, but decided ill ask before doing something I don't need to. Any advice would be well appreciated.
Almost finished with it Will finish the shocks tomorrow and also I noticed one of my shock look shorter that the other of the rear shocks.

 

[Nicochau]

Hi Alan,

servo should fit snug, but no need to drill anything. What servo are you using?

 

[Alan0823]

Hi Alan,

servo should fit snug, but no need to drill anything. What servo are you using?

I'm using a savox DS3225 i woke up this morning and got it to fit i just didn't wanna smash my wire on the back of it up against the walls of the box. Sorry for the responce delay.

 

[Alan0823]

Ok finally i completed my MT410 build got the servo in the right way and here's a pic of my setup.
1. 120 Arrma BLX ESC
2. Motor a hobby star 3670 3050kv. With for now! 20t pinion, cause I'm waiting on an order of the smaller mod1 pinions to come in the mail.
3. 6000mah 4s Zeee soft pack battery.
4. Remote and Receiver the Fly Sky FS-GT3C.
If any suggestions give them I love any help to make my build better.

 

[freelosophy]

make sure you adjust the droop screw, I forgot to do it. If you gonna bash a lot with it you may want to check out M2C braces to keep the chassis from bending. I love my mt410! would love to relive the build experience it was such a nice kit to put together!

 

[Alan0823]

Where is the droop screw on the truck sorry im new to all this. Lol

 

[Alan0823]

We'll here's the final product with the wheels on got to find a wheelie bar now it won't stay down. Lol