bquach
New member
- Messages
- 4
- Reaction score
- 2
I wanted to run a stadium truck body on the ET410 and saw a few creative solutions across the internet. However, I wanted to be able to run an ST body or stock body without too much hassle. Came upon body mount extensions during my search and the gamble paid off.
Bought this off amain.
It had four post extensions for 5.5mm diameter and 6mm diameter. 6mm diameter extensions are a direct fit, with the 5.5mm being snug (but decided to use them anyway).
The only modification needed was to cut the tip of the round mount point on the ET410. Did this on all four mounting points. This is because the inside of the extension post is flat.
Front Mount Extensions
Rear Mount Extensions
Mounted TLR 22T body.
The posts will be cut and sanded down a few notches higher than the retention pins in case I decide to use another body. There are a few other extension options found on eBay as well.
If I want to run stock body, just remove extension and mount body as normal. Hope this is useful!
Bought this off amain.
It had four post extensions for 5.5mm diameter and 6mm diameter. 6mm diameter extensions are a direct fit, with the 5.5mm being snug (but decided to use them anyway).
The only modification needed was to cut the tip of the round mount point on the ET410. Did this on all four mounting points. This is because the inside of the extension post is flat.
Front Mount Extensions
Rear Mount Extensions
Mounted TLR 22T body.
The posts will be cut and sanded down a few notches higher than the retention pins in case I decide to use another body. There are a few other extension options found on eBay as well.
If I want to run stock body, just remove extension and mount body as normal. Hope this is useful!